Eco+ Table
5 simple steps for any stain

Prompt and immediate attention to spillages or stains is recommended to avoid the penetration of a stain into the carpet fibres. Care must be taken to treat stains as recommended below…

1.

Immediately remove as much of the spill as possible. For solids use a blunt knife or spoon. Blot up liquids by applying pressure with white paper towels or tissues. Use a wet/dry vacuum for large spills.

2.

Cold water and an absorbent sponge is all that’s needed to remove most stains from Godfrey Hirst eco+ carpets. Always work from the outside of the stain or spillage towards the middle to avoid further spreading using a blotted or dabbing motion. If the stain persists, gentle rubbing is advised but use caution to avoid altering the texture of the carpet.

3.

Once the stain has been removed with cold water. Press dry with a clean white cloth or white paper towel.

4.

After the spill or stain has been treated, place several layers of white paper towel over the area and place a flat weight on them until dry. Do not walk on the carpet until dry.

5.

If the stain fails to respond, repeat the above treatment until no stain is evident (this process may need to be repeated over a number of days).